AuricSound A7 new Remote add-on functional demo video
TECHNICAL DETAILS
AUDIO INPUTS
1x pair RCA (stereo) (A). Gain 3dB; 1.4Vrms in for 2Vrms out.
1x 3.5mm analogue stereo (B). Gain 12dB; 500mVrms in for 2Vrms out. Analogue inputs overload capability >40dB
AUDIO OUTPUTS
1x pair Balanced XLR out. Vacuum Tube amp Maximum output 3Vrms off load, THD <0.002%. Output impedance <100mΩ. Power output 250mW up to 42Ω. Short-circuit protected
1x 1/4in A-type stereo phone jacks. Max output 3Vrms off-load, THD <0.002%. Output impedance 2.2Ω
PERFORMANCE
Output noise (input A1) < –100dBV CCIR or A weighted
2x output sets per channel, terminal posts (stereo) Hi-Res amp out.
PERFORMANCE
Distortion – less than 0.01% input to output Signal/Noise -better than –100dB 50W + 50W continuous amplification driving all channels (4~8 Ω) Frequency response +0/–1dB DC–70kHz, +0/–3dB DC–200kHz
COMPATIBILITY
Suitable for impedances in the range 16–1kΩ or more. Suitable for open, closed, in-, on- or over-ear models. Recommended sensitivity >80dBspl/mW or >96dBspl/V
CONTROLS
Volume with precise tracking, 70dB range Power including rear output mute
DIMENSIONS
HEIGHT: 68mm
WIDTH: 193mm
DEPTH: 160mm
AuricSound Products Roadmap and Delivery 2017
Risks and challenges
The risks of this project are low. We have already finished a lot of prototyping, material research and testing as well as already produced a small batch of pre-production units with our established suppliers. PCB’s are already fully functional but might undergo another revision. The firmware will undergo further optimizing for minor usability and sound improvements. The enclosure has undergone several prototyping cycles already, we’ve tested a range of materials, gluing, folding and printing technologies. The side panels are already injection molded samples and just need a few slight adaptions.
Of course it can still happen that there are minor delays, because we can’t foresee everything. Surprises lurk everywhere.
Be the first to review “AuricSound A7 Vacuum Tube Amp XLR Stereo Hybrid”